McDATA OPENconnectors Command Line Interace Manual do Utilizador descarregar pdf (Página 253)

Error Messages

A-13

Message Error 081: Default Zone Enabled

Description The request cannot be completed because the default zone is enabled

Action Disable the default zone and re-submit the command.

Message Error 082: Invalid Interop Mode

Description The value entered for the interoperability mode is not valid.

Action The interoperability mode for the director or switch must be mcdata

(McDATA Fabric 1.0) or open (Open Fabric 1.0). Make the

appropriate changes and re-submit the command.

Message Error 083: Not Allowed in Open Fabric Mode

Description This request cannot be completed while this switch is operating in

Open Fabric 1.0 mode.

Action Configure the interop mode to McDATA Fabric 1.0 mode.

Message Error 088: Invalid Feature Key Length

Description The feature key installed is longer than the maximum length allowed.

Action Be sure that the key has been entered correctly and re-submit. Contact

your sales representative with any further problems.

Message Error 090: Invalid Port Type

Description The port type configured is invalid.

Action A port may be configured to be an eport, gport, or fport. Be sure the

port is configured appropriately and re-submit the command.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 327 328

Sem comentários

McDATA OPENconnectors Command Line Interace Manual do Utilizador Página 253