McDATA OPENconnectors Command Line Interace Manual do Utilizador descarregar pdf (Página 208)

2-164

Enterprise Operating System Command Line Interface User Manual

show

Output Example The output from the show.port.config command displays as follows.

Port Name Blocked FAN Type Speed Rx Crdts

---- -------------- ------- ------- -------- ----- ---------

0 Port_0_name Blocked Enabled gxPort Negotiate 12

1 Blocked Enabled gxPort Negotiate 12

2 locked Enabled gxPort Negotiate 12

...

show.port.exit

Syntax exit destDomainID sourcePort

Purpose This command displays the exit port from a source port to a given

destination domain. This command shows the Preferred Path

configuration.

Use all for one of the command’s parameters to display all configured

and actual exit ports for either the destination domain ID or the

specified source Port. You cannot specify all for both parameters. If

the destination domain is set to all, then all paths from the specified

source port are displayed. If the source port is set to all, the output

shows all source port paths to the specified domain.

FAN The configured fabric address notification

(FAN) state. (Sphereon 4300 and Sphereon 4500

switches only.)

Type The port type as set in the config.port.type

command.

Speed The port speed as set in the config.port.speed

command.

Rx Crdts The number of Rx BB Credits as set in the

config.port.rxCredits command.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 327 328

Sem comentários

McDATA OPENconnectors Command Line Interace Manual do Utilizador Página 208