McDATA OPENconnectors Command Line Interace Manual do Utilizador descarregar pdf (Página 125)

CLI Commands

2-81

config

Parameters This command has one parameter:

Command Example

Root> config switch zoneFlexPars fabric

config.switch.zoningRSCN

Syntax zoningRSCN zoningRSCNState

Purpose This command sets the zoning RSCN state for the switch. When

enabled, this parameter allows zoning register for state change

notifications (RSCNs) to be sent to registered members of the fabric.

Zoning RSCNs are sent to ports on the switch following any change

to the fabric’s active zone set. The switch can be either offline or

online when this command is executed.

Parameters This command has one parameter.

Command Example

Root> config switch zoningRSCN 1

config.system.contact

Syntax contact systemContact

Purpose This command sets the system contact attribute.

zoneFlexParsState This parameter can be set to fabric and

none. When set to fabric, RSCNs will only

be sent to affected fabric members when

zoning information changes. When set to

none, filtering of RSCNs will not take

place, and RSCNs will be sent to all

zoneset members when zoning

information changes

zoningRSCNState Specifies whether the zoning RSCN state is

enabled. Valid values are enable, disable, true,

and false. Boolean 1 and 0 may be substituted as

values.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 327 328

Sem comentários

McDATA OPENconnectors Command Line Interace Manual do Utilizador Página 125