McDATA OPENconnectors Command Line Interace Manual do Utilizador descarregar pdf (Página 107)

CLI Commands

2-63

config

NOTE: The starting IP address must be lesser than the ending IP address.

Command Example Root> config security switchAcl addRange 10.0.0.0

10.0.0.2

config.security.switchAcl.deleteRange

Syntax deleteRange startIPAddress endIPAddress

Purpose This command deletes a range of IP addresses from the access control

list. This range must exactly match one of the existing ranges in the

access control list.

Parameters This command has the following parameters:

Command Example

Root> config security switchAcl deleteRange 10.0.0.0

10.0.0.2

config.security.switchAcl.setState

Syntax setState aclEnabledState

Purpose This command sets the enabled state of the access control list. In

order for the access control list to be enforced, the state must be set to

enable.

Parameters This command has one parameter:

startIPAddress The starting IP Address of the range to be

deleted. The address must be entered in dotted

decimal form (such as, 10.0.0.0).

clear - Using the optional 'clear' parameter by

itself will remove all of the entries from the

access control list.

endIPAddress The ending IP Address of the range to be

deleted. The address must be entered in dotted

decimal form (such as, 10.0.0.0).

aclEnabledState This parameter can be set to enable or disable.

Boolean 1 and 0 values may also be substituted.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 327 328

Sem comentários

McDATA OPENconnectors Command Line Interace Manual do Utilizador Página 107