McDATA OPENconnectors Command Line Interace Manual do Utilizador descarregar pdf (Página 120)

2-76

Enterprise Operating System Command Line Interface User Manual

config

Parameters This command has one parameter.

Command Example

Root> config switch priority principal

config.switch.raTOV

Syntax raTOV timeoutValue

Purpose This command sets the R_A_TOV for the switch.

NOTE: The switch must be set offline before this command is entered.

Special care should be used when scripting this command due to its

relationship with E_D_TOV.

Priority Specifies the switch priority. Valid values are:

principal, default, or neverprincipal.

principal — sets the numerical switch priority

to 1. The switch with a priority of 1 becomes the

principal switch; however, if two or more

switches have a priority of 1, the switch with

the lowest WWN becomes the principal switch.

default — sets the numerical switch priority

to 254. If no switch is set to principal, the switch

with a priority 254 becomes the principal

switch; however, if two or more switches have a

priority of 254, the switch with the lowest

WWN becomes the principal switch.

neverprincipal — sets the numerical switch

priority to 255. This switch is not able to become

the principal switch.

At least one switch in a multiswitch fabric must

have a switch priority value of principal or

default.

The number codes 2–253 are not now in use.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 327 328

Sem comentários

McDATA OPENconnectors Command Line Interace Manual do Utilizador Página 120