McDATA 4416 Guia de Instalação descarregar pdf (Página 10)

McDATA 4416 Switch Module Release Notes Firmware Version 5.2.3.13.00 GUI Version 5.02.3.07 P/N

Other Notes and Considerations

• When logged in to the McDATA 4416 switch via the Dell

DRAC/MC, the console output is erratic. It appears that CR

(carriage returns) are not being interpreted correctly. This is a

problem on Linux systems only. Consider the following remedies:

— Connect directly to the FC switch through Telnet instead of

logging in through the Dell DRAC/MC

— Connect a NULL modem cable between the Linux system and

the Dell DRAC/MC and set the baud rate to 115200.

— Contact Dell technical support to see if new Dell DRAC/MC

code is available.

• SNMP Proxy is enabled by default on the McDATA 4416 Switch.

This can cause the following display issues when using Element

Manager:

— The Zoning dialog does not display all switch modules.

— Nodes attached to switch modules do not display in the

product list or in the zoning dialog.

— The active firmware is not displayed correctly in the product

list.

— No fabric is displayed in the topology display when multiple

switch modules are in a fabric but only 1 switch is discovered

To avoid these display issues, you must disable SNMP Proxy. To

disable the SNMP Proxy, open a Telnet session on the switch, log

in, and enter the following commands:

admin start

set setup snmp

(set the ProxyEnabled setting to False)

Do you want to save and activate this snmp setup? (y/n):

[n] y

• When upgrading the firmware on the McDATA 4416 switch using

McDATA Embedded Web Server or Element Manager, the

firmware upgrade process may fail with the following message:

The upload process failed

This failure may be due to an File Transfer Protocol (FTP) proxy or

Network Address Translation (NAT) router that exists on the

Ethernet backbone which does not support, or is blocking,

passive FTP mode.

1 2 ... 5 6 7 8 9 10 11 12

Sem comentários

McDATA 4416 Guia de Instalação Página 10