McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Guia do Utilizador descarregar pdf (Página 125)

100

101

Configuring an F_Port Extension over an Ethernet WAN

6-19

Configuring a 2x2 Ethernet Wide Area Network

NOTE: If you do not know what the default gateway (the router IP address

attached to the UltraNet Edge 3000) is at this point, you can add the static

route at a later time. To add static routes at a later time, see

Appendix E,

Static Routes.

15. Check Set, enter the IP Address of the router directly attached to

Node20 to set the static route.

NOTE: If you are using the Configuration IP Address Worksheet from Appendix

J, enter the following information:

For Node20, enter the gateway address labeled for the circuit on a 1x1 or

2x1 configuration or the 1st circuit of a 2x2 or 1x2.

For the 2nd circuit of a 2x2 or 1x2 configuration, enter the gateway address

labeled .

16. Click Next>.

The IP Circuit Wizard Configure Circuit dialog box appears.

This dialog box enables you to configure the circuit properties.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 427 428

Comentários a estes Manuais

Sem comentários

McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Guia do Utilizador Página 125

Comentários a estes Manuais

Manuais e produtos relacionados com Redes McDATA ULTRANETTM EDGE STORAGE ROUTER 3000